Position sizing
Also called position size, trade sizing, fixed-fractional sizing, fixed fractional, money management
Deciding how many units, lots or contracts to trade so that the loss, if the stop-loss is hit, equals an amount set in advance, such as a fixed fraction of the account.

- Level
- Intermediate
- Reading
- 2 min
- Sources
- 3Professional bodyBookRegulator
- Updated
On this page· 5 sections
Two traders can take the same trade, with the same entry and the same stop, and still lose different amounts. The difference is size. Position sizing is the step between a trade idea and an order: it sets how much to buy or sell.
Risk-based sizing starts from the loss, not from the money available. It asks how much the trade may lose if the stop is hit, then works back to the size.
How it works
Fixed-fractional sizing risks the same fraction of current capital on every trade. It is the rule behind the Kelly criterion, where an investor who repeats a bet must invest the same fraction each time[1]. Because the fraction applies to current capital, positions shrink after losses and grow after gains.
The size then follows from three numbers:
- the risk amount: account value × risk fraction;
- the stop distance: how far the stop sits from the entry, in pips, points or ticks;
- the value of one pip or point for one lot or contract.
Position size = risk amount ÷ (stop distance × value per pip).
Choosing the fraction is a trade-off. Too small an allocation gives up growth; too large, and a few unlucky outcomes, even one, can damage an account beyond recovery[1]. The Kelly criterion sets the fraction from the odds: Kelly % = W/A − (1 − W)/B, where W is the chance of a win, B the gain on a win and A the loss on a loss[1]. Most investors scale it down because they will not tolerate the drawdowns it brings[1].
Ralph Vince’s The Mathematics of Money Management (1992) treats which markets to trade, and in what quantities, as a mathematical problem, built around a measure called optimal f[2].
Example
Say a trader has $10,000 and risks 1% per trade, so $100. The trade is EUR/USD with a stop 25 pips from the entry. Assume one standard lot is 100,000 euros and a pip is 0.0001, so one lot moves $10 per pip.
- Position size = $100 ÷ (25 × $10) = 0.4 lots.
- Check: if the stop is hit, 0.4 lots × $10 × 25 pips = $100.
- With a 50-pip stop, the same $100 allows 0.2 lots.
- After losses take the account to $9,000, 1% is $90, and the 25-pip trade becomes 0.36 lots.
Watch out
Margin is not risk. Leverage lowers the deposit needed to open a trade, but it magnifies trading losses and costs[3]. The loss at the stop depends on the full position, not on the margin posted.
Pip value is not always $10. On USD/JPY a pip is 0.01 yen, so a 100,000-dollar lot moves 1,000 yen per pip, about $6.67 at a rate of 150.
The plan assumes the stop fills at its price. A worse fill, called slippage, makes the loss larger than planned.
A fixed fraction slows a losing streak; it does not stop one. Ten losses in a row at 1% leave about 90.4% of the account. At 2%, about 81.7%.
Sources
- Professional bodyCFA Institute, Enterprising InvestorThe Kelly Criterion: You Don't Know the Half of ItChecked November 8, 2026
- BookRalph Vince, Wiley (1992)The Mathematics of Money Management: Risk Analysis Techniques for TradersChecked November 8, 2026
- RegulatorFinancial Conduct Authority (FCA)Multi-firm review of contracts for difference providers’ provision of price and valueChecked November 8, 2026
