New$10 Sign Up Bonus & $30 Free Trial Reward
Start challenge

Volume-weighted average price

Also called VWAP

The total value traded in a session divided by the total volume traded, so prices with more trading count more. Institutions use it to judge execution quality; on charts it is an intraday line that resets each session.

Reading
2 min
Sources
4BookReferenceExchangeProfessional body
Updated
On this page· 5 sections
  1. How it works
  2. Example
  3. Watch out
  4. Sources
  5. Related terms

Volume-weighted average price (VWAP) answers one question about a session: at what price did the average share change hands? Each trade counts in proportion to its size, so a block of 1,000 shares weighs a thousand times as much as a single share[1][2].

It began as a yardstick for institutions. A fund that buys a large position over a day can compare its average fill with the day’s VWAP to judge how well the order was worked[1][2]. Charting platforms now plot the same number as an intraday line for individual traders too[2].

How it works

VWAP = total value traded ÷ total volume traded, over one session[1].

StockCharts builds its chart line from intraday bars, where traditional VWAP uses every trade[2]:

  1. Typical price of each bar = (high + low + close) ÷ 3.
  2. Multiply it by the bar’s volume and keep a running total.
  3. Keep a running total of volume.
  4. VWAP = running price-volume total ÷ running volume total.

The line starts fresh at each open, so its first value is that bar’s typical price, and it is not defined on daily or longer bars[2]. Because it is cumulative, it lags more as the day goes on: on a one-minute chart, a 390-minute trading day ends with 390 data points[2].

Chartists read the direction of the line, and where price sits against it, as a guide to the intraday trend[2]. The same arithmetic sets some official prices. In CME Group’s description, the daily settlement price of the front month in most equity index futures is a VWAP of the last 30 seconds of the trading day[3].

Example

Say a stock trades three blocks in a session: 1,000 shares at $20.00, 3,000 at $20.40 and 1,000 at $19.80.

  1. Value traded = $20,000 + $61,200 + $19,800 = $101,000.
  2. Volume = 5,000 shares.
  3. VWAP = $101,000 ÷ 5,000 = $20.20.

The plain average of the three prices is $20.07. VWAP sits higher because most of the volume traded at $20.40. A purchase filled at $20.10 came in below VWAP, which StockCharts calls a good fill; for a seller, the same $20.10 was below average[2].

Watch out

VWAP is a reference for one day, not a forecast. It shows where the day’s volume changed hands, which is why StockCharts calls it best suited to intraday analysis[2].

Early values are unstable. With few bars in the totals, the line swings near the open and steadies later[2].

Two platforms can show different VWAP lines for the same stock, depending on whether they use ticks or bars of a given length[2].

As a signal on a chart, VWAP faces the same mixed evidence as other technical rules. Park and Irwin’s 2004 review, quoted by the CFA Institute Research Foundation, found more studies reporting profitable technical strategies than not[4]. In futures markets, though, such strategies appeared profitable only between the mid-1970s and the mid-1980s, and as of 2004 no study had comprehensively documented profits after that[4].

All terms in Tronexopedia

Your challenge starts here

Start your challengeFree TrialNew
Registration bonus

Get $10 free in your Wallet when you sign up

Register and use your $10 Wallet credit to reduce the price of your first challenge.

The $10 bonus is credited to your personal Wallet and can only be used to reduce the price of a challenge purchase. Credits cannot be withdrawn or used for payouts.

Start now & get $10